| Table of contents |
Max Input Channels: 8 (single-ended)
A/D Resolution: 8 bits (1/256 of full-scale)
Input Ranges (Bipolar, -DX version only): ±5V, ±2.5V, or ±1.25V
Input Ranges (Unipolar, both versions): 0-5V, 0-2.5V, or 0-1.25V
Data Ranges (Bipolar, -DX version only): -128 to +127
Data Ranges (Unipolar, both versions): 0 to 255
Supported Conversion Triggers: Software, Internal Clock, or External TTL Signal
Maximum Conversion Rate (software or interrupt routine): 40,000 (approx.) samples per second
This board does not support programmable input ranges and resolutions. To change these settings, you must adjust the hardware jumpers on the board.
Max Output Channels: 1
D/A Resolution: 8 bits (1/256 of full-scale)
Output Ranges (Bipolar, -DX version only): ±2.5V or ±1.25V
Output Ranges (Unipolar, both versions): 0-2.5V or 0-1.25V
Data Ranges (Bipolar, -DX version only): -128 to +127
Data Ranges (Unipolar, both versions): 0 to 255
Max Ports: 3 (bi-directional, programmable in 4- or 8-bit groups, TTL-compatible) based on 82C55
Digital I/O ports on Zircon-MM require direction to be set with dscDIOSetConfig() before use.
All DIO lines power-up in input mode and have readback capability.
All DIO lines have 10K Ohm pull-up resistors.
This page was last modified 12:47, 12 Feb 2004.
Copyright (c) 2004 Diamond Systems. All Rights Reserved.